Stainless Works SSS010 Stainless Steel Beverage Dispenser Spigot (Fits 5/8 inch opening)

Stainless Works Stainless Steel Spigot is designed to replace the cheap, easy to break and leaky plastic spigot on the market. Our spigots look elegant, feel solid, and last a lifetime(backed up by our life time warranty)

Stainless Works SSS010 Use and Care Instruction:
Before installation, wash in soapy water and rinse suggested
Remove the nut, and one set of washer, gasket from the spigot
Insert the spigot to the despenser
Install the gasket and washer
Tight the nut. Usually hand-tight is good enough to create a water tight seal. You can also use 3/4 in wrench. Do not over-tighten, it could crack the despenser made of fragile material like glass or ceramic.
After each use, rinse thoroughly with clean water with handle in partial open position(45 degree turn)
If used for sugary drink, we suggest that remove spigot from the dispener and clean throughly.

Package Content: 1 stainless steel spigot, 2 stainless steel washer, 2 silicon gasket, 1 stainless Steel nut. Warranty informaton is provided on the package.

Our Staineless Works Products:
SSS010: Best Flow Rate at 3 sec/cup with 8 inch water
SSS012: Fits smaller holes(12mm or half inch), Flow Rate at 5 sec/cup
SSS016: Smoothest and effortless turning with limited flow, Flow Rate at 9 sec/cup
SSS020: Classic Design, Good Value. Flow Rate at 7 sec/cup .

We are selling spigot with chalkboard labels.
Check Model Number: SSS010-10L, SSS012-10L and SSS016-10L