RV Boat Sailboat Deep Cycle Battery Desulfator 6V-12V

A battery desulfator is an electronic device that cleans the internal battery plates to remove lead sulfate. This lead sulfate will form on the batteries internal plates and greatly reduces the capacity of a charge on a battery. By restoring the lead sulfate back into the acid solution you can greatly extend the life of the battery. Our product is designed to be left connected "full-time" to the battery and will provide many years of maintance free operation. This product will work on all types of lead based batteries. It is recommended that a small trickle style charger in the 1-2 amp range be used when recovering a battery. Large high current, bulk rate chargers, will quickly cause heat build up in the battery and could boil the acid causing a very dangerous condition. For large battery systems, like that of a golf cart or solar battery bank, one desulfator is required per battery. This product will desulfate batteries ranging from 1 amp hour to 1000 amp hours. Due to the wide range of battery types and post configurations, we do not include ring lug terminals with our product. INSTALLATION INSTRUCTIONS (1.) The Wizbang desulfator should be installed as close as possible to the battery terminals. (2.) You many trim the wire leads back with wire cutters/strippers to work best for your application. (3.) Install the Red wire to the positive (+) terminal on your 6, 8 or 12 volt battery. (4.) Install the Black wire to the negative(-) terminal on your 6, 8 or 12 volt battery. (5.) Verify that the red LED is on, you might also be able to hear a "buzzing" noise. (6.) The best results for recovery will occur within the first 4 weeks. If left connected longer, desulfating will continue but at a slower pace. (7.)The Wizbang desulfator has a built in auto ranging feature that will automatically adjust for different battery voltages. (8.) Your done. Happy desulfating. INPUT VOLTAGE 4.5Vdc - 16Vdc