DiamondNite Tester DN1 One Touch Diamond and Moissanite


DiamondNite Tester DN1
by:Oris Nelson Enterprise, Inc.
This is the first and only one step dual tester. This new revolutionary design is unmatched in performance and ease of use. The entire test takes only ONE second and then you know for sure if it's moissanite, other artificial diamond, or a genuine diamond. This device is 100% accurate and patent pending.
One Touch Diamond and Moissanite Tester
OPERATION INSTRUCTIONS:
Turn unit on with adjustment knob
Wait until wait light goes off and ready light comes on, approximately 10 seconds
Hold tester with right hand so that your fingers are resting on the rear metal plate and your other hand must hold the metal holding the gem stone or the metal test plate.
Lightly touch the probe tip in the center of the gem stone. Hold tester perpendicular to the table of the gem for one second
If it's a simulant or non-diamond, nothing will happen. If it's a diamond the buzzer will ring and the green light (diamond) will come on for about 6 seconds. If it's a moissanite the tone will change and the lights will switch from green to red (moissanite) with in 1/2 second.
After the buzzer is first heard you must continue to test for one second before you take the probe off the gem stone. This is because the test for diamond is done first. The test for moissanite is completed 1/2 second later.
If the tone changes while you are removing the probe, you must re-test because you may have contacted the metal findings while removing the probe.
To save the battery turn off the unit after testing. If you forget, the tester will remind to do so in three minutes.
If the yellow ready light flashes or doesn't come on, you need to replace the 9v battery. Alkaline batteries are recommended.